| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
erofs: add GFP_NOIO in the bio completion if needed
The bio completion path in the process context (e.g. dm-verity)
will directly call into decompression rather than trigger another
workqueue context for minimal scheduling latencies, which can
then call vm_map_ram() with GFP_KERNEL.
Due to insufficient memory, vm_map_ram() may generate memory
swapping I/O, which can cause submit_bio_wait to deadlock
in some scenarios.
Trimmed down the call stack, as follows:
f2fs_submit_read_io
submit_bio //bio_list is initialized.
mmc_blk_mq_recovery
z_erofs_endio
vm_map_ram
__pte_alloc_kernel
__alloc_pages_direct_reclaim
shrink_folio_list
__swap_writepage
submit_bio_wait //bio_list is non-NULL, hang!!!
Use memalloc_noio_{save,restore}() to wrap up this path. |
| In the Linux kernel, the following vulnerability has been resolved:
gpio: omap: do not register driver in probe()
Commit 11a78b794496 ("ARM: OMAP: MPUIO wake updates") registers the
omap_mpuio_driver from omap_mpuio_init(), which is called from
omap_gpio_probe().
However, it neither makes sense to register drivers from probe()
callbacks of other drivers, nor does the driver core allow registering
drivers with a device lock already being held.
The latter was revealed by commit dc23806a7c47 ("driver core: enforce
device_lock for driver_match_device()") leading to a potential deadlock
condition described in [1].
Additionally, the omap_mpuio_driver is never unregistered from the
driver core, even if the module is unloaded.
Hence, register the omap_mpuio_driver from the module initcall and
unregister it in module_exit(). |
| In the Linux kernel, the following vulnerability has been resolved:
nfc: nci: fix circular locking dependency in nci_close_device
nci_close_device() flushes rx_wq and tx_wq while holding req_lock.
This causes a circular locking dependency because nci_rx_work()
running on rx_wq can end up taking req_lock too:
nci_rx_work -> nci_rx_data_packet -> nci_data_exchange_complete
-> __sk_destruct -> rawsock_destruct -> nfc_deactivate_target
-> nci_deactivate_target -> nci_request -> mutex_lock(&ndev->req_lock)
Move the flush of rx_wq after req_lock has been released.
This should safe (I think) because NCI_UP has already been cleared
and the transport is closed, so the work will see it and return
-ENETDOWN.
NIPA has been hitting this running the nci selftest with a debug
kernel on roughly 4% of the runs. |
| In the Linux kernel, the following vulnerability has been resolved:
can: bcm: fix locking for bcm_op runtime updates
Commit c2aba69d0c36 ("can: bcm: add locking for bcm_op runtime updates")
added a locking for some variables that can be modified at runtime when
updating the sending bcm_op with a new TX_SETUP command in bcm_tx_setup().
Usually the RX_SETUP only handles and filters incoming traffic with one
exception: When the RX_RTR_FRAME flag is set a predefined CAN frame is
sent when a specific RTR frame is received. Therefore the rx bcm_op uses
bcm_can_tx() which uses the bcm_tx_lock that was only initialized in
bcm_tx_setup(). Add the missing spin_lock_init() when allocating the
bcm_op in bcm_rx_setup() to handle the RTR case properly. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: wlcore: Fix a locking bug
Make sure that wl->mutex is locked before it is unlocked. This has been
detected by the Clang thread-safety analyzer. |
| In the Linux kernel, the following vulnerability has been resolved:
rust_binder: call set_notification_done() without proc lock
Consider the following sequence of events on a death listener:
1. The remote process dies and sends a BR_DEAD_BINDER message.
2. The local process invokes the BC_CLEAR_DEATH_NOTIFICATION command.
3. The local process then invokes the BC_DEAD_BINDER_DONE.
Then, the kernel will reply to the BC_DEAD_BINDER_DONE command with a
BR_CLEAR_DEATH_NOTIFICATION_DONE reply using push_work_if_looper().
However, this can result in a deadlock if the current thread is not a
looper. This is because dead_binder_done() still holds the proc lock
during set_notification_done(), which called push_work_if_looper().
Normally, push_work_if_looper() takes the thread lock, which is fine to
take under the proc lock. But if the current thread is not a looper,
then it falls back to delivering the reply to the process work queue,
which involves taking the proc lock. Since the proc lock is already
held, this is a deadlock.
Fix this by releasing the proc lock during set_notification_done(). It
was not intentional that it was held during that function to begin with.
I don't think this ever happens in Android because BC_DEAD_BINDER_DONE
is only invoked in response to BR_DEAD_BINDER messages, and the kernel
always delivers BR_DEAD_BINDER to a looper. So there's no scenario where
Android userspace will call BC_DEAD_BINDER_DONE on a non-looper thread. |
| Spring MVC and WebFlux applications are vulnerable to stream corruption when using Server-Sent Events (SSE). This issue affects Spring Foundation: from 7.0.0 through 7.0.5, from 6.2.0 through 6.2.16, from 6.1.0 through 6.1.25, from 5.3.0 through 5.3.46. |
| fs/splice.c in the splice subsystem in the Linux kernel before 2.6.22.2 does not properly handle a failure of the add_to_page_cache_lru function, and subsequently attempts to unlock a page that was not locked, which allows local users to cause a denial of service (kernel BUG and system crash), as demonstrated by the fio I/O tool. |
| The Solaris pollset feature in the Event Port backend in poll/unix/port.c in the Apache Portable Runtime (APR) library before 1.3.9, as used in the Apache HTTP Server before 2.2.14 and other products, does not properly handle errors, which allows remote attackers to cause a denial of service (daemon hang) via unspecified HTTP requests, related to the prefork and event MPMs. |
| The nlmclnt_mark_reclaim in clntlock.c in NFS lockd in Linux kernel before 2.6.16 allows remote attackers to cause a denial of service (process crash) and deny access to NFS exports via unspecified vectors that trigger a kernel oops (null dereference) and a deadlock. |
| The kernel in Sun Solaris 8, 9, and 10, and OpenSolaris before snv_103, does not properly handle interaction between the filesystem and virtual-memory implementations, which allows local users to cause a denial of service (deadlock and system halt) via vectors involving mmap and write operations on the same file. |
| net/ipv4/udp.c in the Linux kernel before 2.6.29.1 performs an unlocking step in certain incorrect circumstances, which allows local users to cause a denial of service (panic) by reading zero bytes from the /proc/net/udp file and unspecified other files, related to the "udp seq_file infrastructure." |
| The inode double locking code in fs/ocfs2/file.c in the Linux kernel 2.6.30 before 2.6.30-rc3, 2.6.27 before 2.6.27.24, 2.6.29 before 2.6.29.4, and possibly other versions down to 2.6.19 allows local users to cause a denial of service (prevention of file creation and removal) via a series of splice system calls that trigger a deadlock between the generic_file_splice_write, splice_from_pipe, and ocfs2_file_splice_write functions. |
| The ptrace_start function in kernel/ptrace.c in the Linux kernel 2.6.18 does not properly handle simultaneous execution of the do_coredump function, which allows local users to cause a denial of service (deadlock) via vectors involving the ptrace system call and a coredumping thread. |
| The inotify_read function in the Linux kernel 2.6.27 to 2.6.27.13, 2.6.28 to 2.6.28.2, and 2.6.29-rc3 allows local users to cause a denial of service (OOPS) via a read with an invalid address to an inotify instance, which causes the device's event list mutex to be unlocked twice and prevents proper synchronization of a data structure for the inotify instance. |
| The kernel in Red Hat Enterprise Linux 3, when running on SMP systems, allows local users to cause a denial of service (deadlock) by running the shmat function on an shm at the same time that shmctl is removing that shm (IPC_RMID), which prevents a spinlock from being unlocked. |
| A memory corruption issue was addressed with improved lock state checking. This issue is fixed in iOS 18.7.2 and iPadOS 18.7.2, iOS 26.1 and iPadOS 26.1, macOS Sequoia 15.7.2, macOS Sonoma 14.8.2, macOS Tahoe 26.1, tvOS 26.1, visionOS 26.1, watchOS 26.1. A malicious application may cause unexpected changes in memory shared between processes. |
| In the Linux kernel, the following vulnerability has been resolved:
sfc: fix deadlock in RSS config read
Since cited commit, core locks the net_device's rss_lock when handling
ethtool -x command, so driver's implementation should not lock it
again. Remove the latter. |
| In the Linux kernel, the following vulnerability has been resolved:
net: usb: r8152: fix resume reset deadlock
rtl8152 can trigger device reset during reset which
potentially can result in a deadlock:
**** DPM device timeout after 10 seconds; 15 seconds until panic ****
Call Trace:
<TASK>
schedule+0x483/0x1370
schedule_preempt_disabled+0x15/0x30
__mutex_lock_common+0x1fd/0x470
__rtl8152_set_mac_address+0x80/0x1f0
dev_set_mac_address+0x7f/0x150
rtl8152_post_reset+0x72/0x150
usb_reset_device+0x1d0/0x220
rtl8152_resume+0x99/0xc0
usb_resume_interface+0x3e/0xc0
usb_resume_both+0x104/0x150
usb_resume+0x22/0x110
The problem is that rtl8152 resume calls reset under
tp->control mutex while reset basically re-enters rtl8152
and attempts to acquire the same tp->control lock once
again.
Reset INACCESSIBLE device outside of tp->control mutex
scope to avoid recursive mutex_lock() deadlock. |
| In the Linux kernel, the following vulnerability has been resolved:
procfs: avoid fetching build ID while holding VMA lock
Fix PROCMAP_QUERY to fetch optional build ID only after dropping mmap_lock
or per-VMA lock, whichever was used to lock VMA under question, to avoid
deadlock reported by syzbot:
-> #1 (&mm->mmap_lock){++++}-{4:4}:
__might_fault+0xed/0x170
_copy_to_iter+0x118/0x1720
copy_page_to_iter+0x12d/0x1e0
filemap_read+0x720/0x10a0
blkdev_read_iter+0x2b5/0x4e0
vfs_read+0x7f4/0xae0
ksys_read+0x12a/0x250
do_syscall_64+0xcb/0xf80
entry_SYSCALL_64_after_hwframe+0x77/0x7f
-> #0 (&sb->s_type->i_mutex_key#8){++++}-{4:4}:
__lock_acquire+0x1509/0x26d0
lock_acquire+0x185/0x340
down_read+0x98/0x490
blkdev_read_iter+0x2a7/0x4e0
__kernel_read+0x39a/0xa90
freader_fetch+0x1d5/0xa80
__build_id_parse.isra.0+0xea/0x6a0
do_procmap_query+0xd75/0x1050
procfs_procmap_ioctl+0x7a/0xb0
__x64_sys_ioctl+0x18e/0x210
do_syscall_64+0xcb/0xf80
entry_SYSCALL_64_after_hwframe+0x77/0x7f
other info that might help us debug this:
Possible unsafe locking scenario:
CPU0 CPU1
---- ----
rlock(&mm->mmap_lock);
lock(&sb->s_type->i_mutex_key#8);
lock(&mm->mmap_lock);
rlock(&sb->s_type->i_mutex_key#8);
*** DEADLOCK ***
This seems to be exacerbated (as we haven't seen these syzbot reports
before that) by the recent:
777a8560fd29 ("lib/buildid: use __kernel_read() for sleepable context")
To make this safe, we need to grab file refcount while VMA is still locked, but
other than that everything is pretty straightforward. Internal build_id_parse()
API assumes VMA is passed, but it only needs the underlying file reference, so
just add another variant build_id_parse_file() that expects file passed
directly.
[akpm@linux-foundation.org: fix up kerneldoc] |
